Detailed Description: SM2A312DQD BANNER MINI-BEAM PHOTOELECTRIC SENSOR
Brand | Banner |
Catalog Description | MINI-BEAM Self-Contained Diffuse Mode Photoelectric Sensor,24 - 240 VAC,Sensing Range: 380 MM,880 NMTR Infrared LED Sensing Beam,Output: SPST SCR Solid-State 2-Wire Minimum Load Current: 5 MILAMP Maximum Steady-State Load Capability: 300 MILAMP to 50 DE |
Connection | 3-Pin Micro-Style Quick Disconnect |
Country Of Origin | USA |
Enclosure | IEC IP67 NEMA 1, 2, 3, 3S, 4, 4X, 12 and 13 Thermoplastic Reinforced VALOX |
Environmental Conditions | 90 PCT At 50 DEG C Relative Humidity |
GTIN | 00662488268411 |
Leakage Current | Off-State Output: Less Than 1.7 MILAMP |
Lens | Acrylic |
Mfr. # | SM2A312DQD |
Operating Temperature | -20 To 70 |
Output | SPST SCR Solid-State 2-Wire; Minimum Load Current: 5 MILAMP; Maximum Steady-State Load Capability: 300 MILAMP to 50 DEG C, 100 MILAMP to 70 DEG C; Inrush Capability: 3 AMP for 1 S (Non-Repetitive), 10 AMP For 1 Cycle (Non-Repetitive); On-State Voltage Drop: Less Than or Equal to 5 V at 300 MILAMP Load And Less Than or Equal to 10 V at 15 MILAMP Load |
Response Time | 8 |
Sensing Beam | 880 NMTR Infrared LED |
Sensing Range | 380 |
Size | 84.8 MM Length X 12 MM Width X 33.3 MM Height X 18 MM Barrel Diameter |
Special Features | Rectangular with M18 barrel housing style; Protected against transient voltages, false pulse on power-up; Controls are located on the rear panel of the sensor and are protected by a gasketed, clear acrylic cover; Totally encapsulated, o-ring sealing, stainless steel screws construction; Overload conditions can destroy ac MINI-BEAM sensors. Directly wiring sensor without load series, across hot and neutral will damage sensor (except emitter models); Low-voltage use requires careful analysis of the load to determine if the sensorÆs leakage current or on-state voltage will interfere with proper operation of the load; The false-pulse protection feature may cause momentary drop-out of the load when the sensor is wired in series or parallel with mechanical switch contacts; Controls are located on rear panel of sensor and protected by a gasketed, clear acrylic cove |
Standard | RU And CSA Listed, CE |
Type | Self-Contained Diffuse Mode Photoelectric Sensor |
Voltage Rating | 24 - 240 |