Lutron PHPM-PA-120-WH Grafik Eye® Phase-Adaptive Power Module; 120 Volt, 16 Amp, Surface Or Recessed Mounting, White

Detailed Description: Lutron Grafik Eye® Phase-adaptive power module in white color offers potential for zone on a Grafik Eye® control unit to dim a fully loaded circuit of lighting. The phase-to-neutral control power rating is 120 Volts and can withstand 120 Volts at 50/60 Hz. Phase-adaptive power module mechanically selects leading/trailing-edge dimming to turn ON/OFF the electrical load at the end. It is compatible with Grafik Eye® 3000 series control units, LP, LCP, GP dimming panels and HomeWorks, HomeWorks QS remote power panels and Lutron three-wire fluorescent dimmers. The power rating of module is 2000 Watts. It can be used for non-dim loads.

Phase-adapter module has 16 Amps/1920 - 4432 Watts of capacity and terminals can accommodate wires of size 2.5 sq.mm or two 12 AWG. Module measures 6.300 Inch x 2.600 Inch x 5.100 Inch. Phase-adaptive power module is surface or recess mounted for easy installation. In real time, RTISS circuitry compensates for incoming line voltage variations. It can be used to control incandescent, electronic low voltage, magnetic low-voltage and neon/cold cathode lighting sources, as well as Lutron Tu-Wire® fluorescent dimming ballasts. Phase-adaptive power module controls incandescent and electronic low voltage sources on the same circuit/control zone.

Phase-adaptive power module load switches between forward phase/leading edge and reverse phase/trailing edge dimming for one zone. It remunerates for ± 2% change in RMS voltage/cycle and ± 2% Hz change in frequency/second. Grafik Eye® Zone can accommodate wires up to three power modules for easy installation. Module offers air-gap off and two LEDs on front of unit provide diagnostic information. Module's minimum load on power module is 10 Watts. Module has non-condensing relative humidity less than 90%. Phase-adaptive power module is UL listed and CSA certified.