Fluke I310S SureGrip™ AC/DC Current Probe; 30 Amp and 300 Amp AC rms or +/-45 Amp and 450 Amp DC, 300 Volt AC RMS or DC, Yellow

Detailed Description: Fluke SureGrip™ Current probe uses Hall Effect technology to measure AC/DC current. It is used with a oscilloscopes and other suitable recording instruments for precise non-intrusive current measurement. Output can be set to zero by manual adjusting the thumbwheel. Current probe has a inrush current rating of 600 Amps. It has a current rating of 30 Amps and 300 Amps AC or +/- 45 Amps and 450 Amps DC. It has an output sensitivity of 10 to 1 mV/A. Current probe comes with a resolution of +/- 50 to +/- 100 milli-Amps. It has a load impedance of greater than 10 kilo-Ohm and lesser than/equal to 100 pico-F.

Current probe has an conductor position sensitivity of +/- 1.5% relative to centre reading. It comes with a battery life of 30 hours. Current probe has a maximum conductor size of 19 mm diameter. It operates at a temperature rating of -10 to +50 deg C. Current probe operates at a humidity of 15 to 85%. It has a voltage rating of 300 VAC/DC. Current probe has a storage temperature rating of -20 to +85 deg C. It includes low battery indicator and cable of 2 m long. Current probe is limited to 300 VAC RMS and has a phase shift of less than 2 deg below 1 kilo-Hz. It has 9 V alkaline power supply. Current probe meets EMC standards.