Size: 9.750 Inch Length x 3 Inch Width x 1.625 Inch Height
Measurement spotlight illuminates hard to see wires in dark enclosures
Automatically change the 4 to 20 Mili-Amp output for remote testing
Power saving features, auto-off, backlight timeout extend battery life
Enables milliamp signal logging to a separate logging device without breaking the loop
Voltage output linear ramp or 25% step output
Automatic time-out (power)-after 15 min ±1 min, Automatic time-out (Backlight) after 2 min ±10 sec
Simultaneous Milli-Amp in-circuit measurement with 24 Volt loop power for powering and testing transmitters
Detailed Description: Fluke Clamp meter is used to measure analog input and output for control system and PLC. Meter has ability to measure output current without breaking loop up to 4 - 20 milli-Amps from the transmitter. It operates at a voltage rating of 10 - 30 Volts and resistance up to 500 Ohm. It captures changing measurement using hold function. Meter accommodates extension cable along with detachable clamp that helps in capturing measurement in tight locations. It comes with sensitivity and resolution of 0.01 milli-Amps. It has built-in spot light that reach dark enclosures. Meter has dual backlit LCD display for measurement. Meter has ability to measure signals in older control system from 10 - 50 milli-Amps using a 99.9 milli-Amps range. It measures 9.750 Inch x 3 Inch x 1.625 Inch.
Amperage Rating | 100m |
Brand | Fluke |
Catalog Description | Milliamp process clamp meters can measure mA signals without breaking the loop. The Fluke 773 mA Clamp Meter is FlukeÆs premier mA Clamp Meter, providing you with the best in troubleshooting and process calibration power. Need more hours in your day. Save time by NOT breaking the loop on 4-20 mA signal measurements. Are you spending time: Taking mA measurements by removing a wire and breaking the loop Calling the control room to isolate a loop Testing analog input/output on a console Troubleshooting devices with mA inputs and outputs Repairing intermittent or erratic 4-20 mA loops Going back to the shop to get extra tools. If you need more time in your busy day take a good look at the Fluke 773 mA Clamp Meters. ItÆs designed to save you time, and money, by eliminating time wasting activities. Now you can troubleshoot and repair 4-20 mA loops without breaking the loop or bringing down the system. |
Enclosure | Hard Plastic |
GTIN | 00095969475822 |
Height | 2.9500 |
Height Unit | IN |
Item Status | A |
Length | 12.5200 |
Length UOM | IN |
Mfr. # | FLUKE-773 |
UNSPSC | 41111905 |
Voltage Rating | 0 to 30 |
Width | 5.8700 |
Width UOM | IN |