One-piece cold shrink terminations
Consists of a high dielectric-constant (High-K) stress control tube insulated with a molded silicone skirted insulator
Each insulator design incorporates an extended base feature which when combined with mastic ensures a seal at the cable jacket end where the termination ground strap is brought out
Contains sufficient material to make 3 terminations (Lugs must be ordered separately)
110 Kilo-Volt basic insulation level
Detailed Description:
3M 4-Skirt QT-II cold shrink termination kit includes three Hi-K silicone rubber terminations, three silicone PST jacket-seal assemblies, three mechanical ground strap assemblies, three mastic seal strips, three strips of Scotch ™ 70 silicone rubber tape, three packs of silicone grease, one Scotch ™ cable preparation kit and one instruction sheet. Kit is ideal for 5 - 15 kilo-Volts tape shield, wire shield and Unishield ® power cables with 1, 1/0, 2, 2/0, 4, 6 and 8 AWG conductor sizes.
Kit is suitable for cables with 0.33 - 0.69 Inch outer diameter insulation. Kit provides easy installation for wide range of indoor and outdoor applications. It consists of Hi-K stress control tube that is insulated with molded silicone skirted insulator. Kit includes adequate material required for three terminations. It has maximum installed length of 13.25 inches. Kit meets the IEEE Standard 48 requirements.
Application | Outdoor |
Brand | 3M |
Catalog Description | 3MÖ Cold Shrink QT II 5630K Series Termination Kit includes three 4 skirt, 1 piece terminations. It ensures a pliable, tight seal for tape shield, wire shield and UniShield« power cables. The conjunction of high dielectric constant material and silicone rubber insulation allows the termination to withstand voltages of 5 to 15kV. |
GTIN | 00054007496816 |
Height | 5.0000 |
Height Unit | IN |
Item Status | A |
Length | 14.2000 |
Length UOM | IN |
Mfr. # | 5632K |
Standard | IEEE |
Type | QT-II |
UNSPSC | 26121648 |
Width | 6.5000 |
Width UOM | IN |